Owner’s Manual 2008 Rev 10.27.08
10 1-1/2” Mini Jets A forceful, steady stream of water/air is delivered from these jets when the pump is on high or low speed. Interchangeable Jet
11 Thermal Spa Cover It is important that you properly care for your spa cover. Do not sit or stand on the cover, as it will break. Do not let sno
12 WATER CARE Your Great Lakes Spa is equipped with what we believe is the finest filtering device available. We call it the Skim/Filter system,
13 SPA CARE AND MAINTENANCE Draining Your Spa Under normal usage, you should change the water in your spa every 3-4 months. Before doing so be sure
14 TROUBLESHOOTING • Equipment Module Will Not Operate • Make sure the spa control is plugged into the control system of the equipment module. • Ch
15 CONTROL PANEL INSTRUCTIONS FOR GECKO IN.XE SYSTEM Key 1 Press Key 1 to turn Pump 1 on at low speed. Press a second time to turn pump to high
16 CONTROL PANEL INSTRUCTIONS FOR GECKO IN.XE SYSTEM On / Off Key Standby Mode: Use On / Off key to pause all pumps for 30 minutes*. Progress bar w
17 TROUBLE SHOOTING / IN.XE ERROR CODES MESSAGE MEANING An internal hardware error has been detected in the in.xe. The system has shut t
18 Thank You! The employees of Great Lakes Spas would like to extend their sincere thanks to you for purchasing a Great Lakes Spa. We hope that
19 GREAT LAKES SPAS LIMITED WARRANTY Emerald Spa Corporation, manufacturer of Great Lakes Spas, (“Emerald Spa Corporation”) extends this Limited Wa
2 TABLE OF CONTENTS Important Safety Instructions ...
3 17. People with infectious diseases should not use the spa. 18. To avoid injury, use care when entering or exiting the spa. 19. Do not use t
4 LOCATION AND INSTALLATION Your spa has been conveniently designed for use in either an indoor or outdoor setting. While selecting an appropriate
5 SPA SET UP This section covers the installation of your spa. All electrical steps must be performed by a licensed electrician. The spa must be con
6 240V Systems Continued 3. Pull four copper current carrying conductors (one each: black, red, white, green). Use either No. 6 AWG 60° C, No. 8
7 240v TO 120v WIRING CONVERSION FOR IN.XE SPA PACKS INSTRUCTIONS FOR CONVERTING HEATER FROM 240V TO 120V These instructions pertain only to those
8 NOTE: The white neutral wire from the back of the GFCI MUST be connected to an incoming line neutral. The internal mechanism of the GFCI requires
9 SPA OPERATION Refer to the Control Panel operating instructions for the spa-side control unit. The operating functions of your spa controller wi
Kommentare zu diesen Handbüchern